Pin this to your DIY Furniture board – Electric Fireplace Mantle Free Plans!

Bed molding is cut just like crown molding – the molding is set upside down in the miter saw to make cuts. In other words, the edge that normally faces the ceiling is placed on the table of the saw. I would recommend cutting 2 end pieces first. Place the molding in position, make a mark and cut a 45 degree angle. Attach 1 end piece using glue and 1″ pin nails. For the center piece, cut a 45 degree angle to match the end piece you just installed, place against that end piece, make a mark at the other end and cut with a 45 degree angle. Test fit the center piece and the remaining end piece. Make any necessary adjustments. Apply glue and attach center piece using 1″ pin nails. Install remaining end piece using glue and 1″ pin nails.